Compiled scripts not running

[BitByteBit]

When I build, or compile the script, it runs the compiler with no errors, however when I try to run the .exe I get an error message. If I just run the code within SciTe it runs perfectly fine, also if I compile it to .a3x then it runs.

I have tried compiling a simple one line program that only shows a messagebox and it still gives the same error, proving it is not my code but the compiler.

Any ideas???

Problem signature:

Problem Event Name: APPCRASH

Application Name: test123.exe

Application Version: 3.3.0.0

Application Timestamp: fcbfa0e6

Fault Module Name: test123.exe

Fault Module Version: 3.3.0.0

Fault Module Timestamp: fcbfa0e6

Exception Code: c0000005

Exception Offset: 000ac003

Locale ID: 1033

Additional Information 1: 0a9e

Additional Information 2: 0a9e372d3b4ad19135b953a78882e789

Additional Information 3: 0a9e

Additional Information 4: 0a9e372d3b4ad19135b953a78882e789

Edited October 18, 2009 by BitByteBit

[water]

Which Windows version?

[BitByteBit]

Which Windows version?

Windows 7, but I didn't have this problem before, I can still run old compiled scripts.

Here is one of the compiled scripts that do not run when compiled (Just in case you would like to see the error message)

The code within this script is:

MsgBox(0,"!","Test")

Edited October 18, 2009 by BitByteBit

[trancexx]

Windows 7, but I didn't have this problem before, I can still run old compiled scripts.

Here is one of the compiled scripts that do not run when compiled (Just in case you would like to see the error message)

The code within this script is:

MsgBox(0,"!","Test")

Either that file or AutoItSC.bin is/was treated with some additional tool.

In both cases the fault is on you for letting it happen.

[Inverted]

That file is UPX'd

Try without using UPX.