jdumont Posted March 17, 2006 Share Posted March 17, 2006 This is my second script and should be a no brainer but all I can think of is it is running too fast or a V2 issue. win2000 on a p3 with 392mb ram I have the Windows Address Book (WAB) with about 2200 addresses. There are some groups under the Main Identity Buddy has been adding new contacts under Main Identity and not under a group. Now he has a few hundred contacts with no group attached. I can write a script and run it from the Quick Launch toolbar one by one and is flawless but when I go to loop it, it starts doing the keystrokes on the wrong part of the window pane. using Repeat or Goto has the same result I start by highlighting the top contact of the list in the right hand pane Send,!{ENTER} gets properties for the contact Send,{TAB 15}{RIGHT 5} the lazy way to get to the "other" tab Send, !G this highlights the Group Membership box so I can focus on it and note if it's empty Sleep,500 zzzzzz Send,{ESCAPE} this closes the properties box for the contact Send, {TAB} this is supposed to highlight(activate) the contact I just looked at Send, {DOWN} this goes to the next contact in the list the problem is the Main Identity folder on the left hand pane gets activated and runs the script from there when i put a doitman: at the top and a Goto,doitman at the bottom Repeat, 100 and EndRepeat has the same result. Oooooooo I just read up on SetKeyDelay. Hopefully that is the ticket. Nope. <sigh> Link to comment Share on other sites More sharing options...
jdumont Posted March 18, 2006 Author Share Posted March 18, 2006 Don't bother.... I fixed it by using a LeftClick, 760,360 As long as i don't highlight any addresses by left clicking in no mans land, it will focus attention on the proper window pane. This allows me to give it the down command to carry on. Link to comment Share on other sites More sharing options...
Recommended Posts