Jump to content

Balloon Ti stem ("tail")


dburner
 Share

Recommended Posts

@dburner...Not sure if this helps....this all I can find in the helpfile for "ToolTip":

If using the center flag, the center of the tooltip will be at the coordinates specified. If using the center flag with a Balloon Tip, the stem will be centered on the balloon and will point to the coordinates specified.

Edited by DjDeep00
Link to comment
Share on other sites

Thanks for the help but i knew that and it dosent help. ;)

The Ballontip has the tail pointed on the upper left corner I need the tail to point at the lower left corner. If i use the center flag the tail will just point at the upper center.

Link to comment
Share on other sites

  • 8 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...