changing size of gui on cliking another Tab

[meYasuo]

i tried

#include <GUIConstantsEx.au3>
#include <TabConstants.au3>
#include <WindowsConstants.au3>

#Region ### START Koda GUI section ### Form=
$Form1 = GUICreate("Form1", 262, 196, 209, 154)
$Tab1 = GUICtrlCreateTab(-8, 0, 265, 193)
GUICtrlSetResizing(-1, $GUI_DOCKWIDTH+$GUI_DOCKHEIGHT)
$TabSheet1 = GUICtrlCreateTabItem("TabSheet1")
$TabSheet2 = GUICtrlCreateTabItem("TabSheet2")
$TabSheet3 = GUICtrlCreateTabItem("TabSheet3")
$TabSheet4 = GUICtrlCreateTabItem("TabSheet4")
GUICtrlCreateTabItem("")
GUISetState(@SW_SHOW)
#EndRegion ### END Koda GUI section ###

While 1
    $nMsg = GUIGetMsg()
    Switch $nMsg
        Case $GUI_EVENT_CLOSE
            Exit
        Case $TabSheet2
            GUICtrlSetResizing($Form1, 102)
            GUICtrlSetPos($Form1, 0, 0, 300, 200)
            WinMove($Form1, "", 0, 0, 300, 200)
    EndSwitch
WEnd

but on clicking TabSheet2 the Gui size was not increased.

how can i set different size of gui for each tab or set new size after clicking another Tab?

Thanxx

[bluelamp]

#include <GUIConstantsEx.au3>
#include <TabConstants.au3>
#include <WindowsConstants.au3>

#Region ### START Koda GUI section ### Form=
$Form1 = GUICreate("Form1",300,200,-1,-1)
$Tab1 = GUICtrlCreateTab(0,0,300,200)
GUICtrlSetResizing(1, $GUI_DOCKWIDTH+$GUI_DOCKHEIGHT)
$TabSheet1 = GUICtrlCreateTabItem("TabSheet1")
$TabSheet2 = GUICtrlCreateTabItem("TabSheet2")
$TabSheet3 = GUICtrlCreateTabItem("TabSheet3")
$TabSheet4 = GUICtrlCreateTabItem("TabSheet4")
GUICtrlCreateTabItem("")
GUISetState(@SW_SHOW)
#EndRegion ### END Koda GUI section ###
While 1
    $nMsg = GUIGetMsg()
    Switch $nMsg
        Case $GUI_EVENT_CLOSE
            Exit
        Case $Tab1
            ConsoleWrite(GUICtrlRead($Tab1)&@CRLF)
            Switch GUICtrlRead($Tab1)
                Case 0
                    WinMove($Form1,"",  Default, Default,300,200)
                Case 1
                    WinMove($Form1,"",  Default, Default, 300, 300)
                Case 2
                    WinMove($Form1,"",  Default, Default, 300, 400)
                Case 3
                    WinMove($Form1,"",  Default, Default, 300, 500)
            EndSwitch
    EndSwitch
WEnd

Here you are

Edited October 2, 2008 by bluelamp