Properties of file

[Groumphy]

Hello,

In the first time my excuses for my English.

I speak only French and Dutch. Nobody's perfect !

I have used for a few days SCITE for AutoIT v3 (Full Install) and and I found some errors:

- 1 - impossible to launch the help file by the F1 key (this is only on my personnal computer, on the computer of my work this is perfect)

- 2 - when I compile script, it is impossible for me to reach the properties of the file (second tab : Ressource Hack). (Also on the computer of my work)

For the first problem, I already reinstalled the applications [fully] (SCITE & AutoIT) but that did not solve.

For the second problem, I downloaded RESHACKER.EXE and installed in the same file as AutoIT but there either that did not solve.

The tab is always inaccessible (gray).

After having sought on the forum (and tried to solve this problem with forum solutions) I gave up (stop) the "solution" of RESHACKER.EXE and tried to use a file INI.

Here the code :

[Autoit]
aut2exe=C:\Program Files\AutoIt3\Aut2Exe\Aut2Exe.exe
icon=C:\Program Files\AutoIt3\Aut2Exe\Icons\favicon.ico
outfile=C:\Documents and Settings\Groumphy\Mes documents\AutoIT v3\Programmes\e-vangelion v3.0 beta\beer_FINDER_Dev_Ver_0.0.7a
Compression=2
PassPhrase=
Allow_Decompile=1
[Res]
UpdateInformation=4
Comment=http://www.digital-nation.be.cx
Description=AutoIt v3 Compiled Script
Fileversion=0.0.7.1
LegalCopyright=digital-nation - 2005 - License : GPL
Field1Name=
Field1Value=
Field2Name=
Field2Value=
[Other]
Run_AU3Check=1
Run_Before=
Run_After=

The INI file is in the same folder of the AutoIT script.

When I compile (always by SCITE), I note that the tab is always gray but is supplemented (completed) with my information ! YOUPIIEEEE

But when I compile script completely (EXE), the properties of the application are always those by default !

I can only say : HEEEELLLPPP !

How can I correct all that ?

1 - The help file ?

2 - Properties of the application ?

Thanks for your help,

[MHz]

Hi Groumphy,

1st. Have a look in the options menu of Scite and open au3.properties. Ensure that at the top of it, shows a correct address, for the autoit directory. As shown below.

# SciTE settings for AutoIt v3 
#
# February 7, 2005 - Jos van der Zande  
# 
# 
# *** Specify here your AutoIt program directory  ***
autoit3dir=C:\Program Files\AutoIt3  <--- CHECK HERE

2nd. Reshacker.exe should be inserted into @ProgramFilesDir & "AutoIt3SciTeCompileAU3" directory. Then you will have full support for changing resources, for compiling.

Edited October 21, 2013 by Jos

[Jos]

If it still doesn't work than PM me in Dutch and i will try to help....

[Groumphy]

Helloooooo,

It's ok with your solutions

"Encore une fois merci !" ;

"Bedankt !" ;

"Thanks you verrrrrryyyy much !" ;

Grouuummphy