Jump to content
Sign in to follow this  
layer

TCP Funcs Q?

Recommended Posts

Hey, I was just wonderin' :( Would you use the "@IpAddress1" or your public Ip that you're able to get from _GetIp() to connect or listen with the TCP funcs?

Thanks : Cause I'm doing some experimenting, and when I use my IP from _GetIp() then obviousky it doesn't create a listening socket because the GUI doesn't show but the script runs for like 2 seconds, and then exits... So this leaves @IpAddress1... But someone could connect to @IpAddress1?

Did I make it clear enough? Just ask if I didn't :">

PS,

Sorry if this should have been in the Dev Section :(

EDIT: Oh yea, the GUI I'm talking about is the example Larry made in the helpfile :)

Edited by layer

FootbaG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...