travo 0 Posted August 11, 2011 I've run into an issue and hope someone can help me. I would like to use autoit to automate the adding and remove of ODBC entries for 32 and 64 bit using the ODBC screens just like I would do manually. The issue I've run into is the getText command seems to work in either the 32 bit ODBC screen or 64 bit screen depending on if I have the 32 bit or 64 bit autoit installed. I was able to use the stop redirection command to get both the 32 bit and 64 bit ODBC screens to launch. However, the gettext command will not read the odbc entries for both, only the 32 bit or 64 bit screens. Thanks, Share this post Link to post Share on other sites