aaronjtroyer 0 Posted September 13, 2011 Hey guys, I'm tying to completely automate a Hyperterminal session. The idea is that I dial in, connect to an energy controller, and then receive a .bin file from the energy controller. I need to have some way to check to make sure it's pulling the data from the controller with the correct serial number. Anyone know an easy way to do this? There are like 60 controllers and I must pull the right file for each serial number. From reading past posts it looks like there's probably no good way to do this but any suggestions would be appreciated. Thanks guys! Share this post Link to post Share on other sites