Inno Setup control will not respond to AutoIt commands - (Moved)

[Slo-Mo]

I am trying to get a response from a control on a third party Installation wizard form created using "Inno Setup".

The form's class is "TWizardForm" and the control's class is "TNewRadioButton".

I can:

1. Get all the form's information using the "AutoIt V3 Window info" tool.

2. Get the form activated/

3. Get the desired control's correct hWnd using its information - proving that all the info about it is actually correct

But, I cannot get it to respond to "Check" or "Click" in any way.

Just to confirm I am using AutoIt correctly, I run the same commands on a standard Windows form and they worked OK.

Is there a known way to get Inno Setup forms and controls to surrender to AutoIt?

 

Thanks in advance!

 

 

[Melba23]

Moved to the appropriate AutoIt General Help and Support forum, as the Developer General Discussion forum very clearly states:

Quote

General development and scripting discussions.

---

Do not create AutoIt-related topics here, use the AutoIt General Help and Support or AutoIt Technical Discussion forums.

Moderation Team

[Danp2]

@Slo-Mo Take a look at the solution provided in this thread.