how would i translate this?

[demandnothing]

i want to use the PixelGetColor to monitor the center of my screen like this:

$x1 = Number( @DesktopWidth/2)
$y1 = Number( @DesktopHeight/2)

$point = PixelGetColor( $x1, $y1)

how would i tell it to click when $point = an array for a certain color? the code it gives for the color in MsgBox is "11141120" and the Hex of the color is "A0000"

i want to do this so that my mouse will only click if it realizes that the target pixel is in the center of the screen.

[demandnothing]

EDIT: nobody knows how i would do this?? or is there just nobody online right now??

Edited August 24, 2009 by demandnothing

[herewasplato]

EDIT: nobody knows how i would do this?? or is there just nobody online right now??

Do not bump your own post so soon - wait at least 24 hours.

[trancexx]

EDIT: nobody knows how i would do this?? or is there just nobody online right now??

Very hard to answer any. I'll try though; - yes, no.

?

[demandnothing]

i would appreciate any help.. thanks trancexx

[billthecreator]

if $point = 0xA00000 Then

MouseClick($x1, $y1)

EndIf

put that in the while, or do until loop. so its always looking

Edited August 24, 2009 by billthecreator

[demandnothing]

thanks but i cant get that to work properly

[billthecreator]

are you setting it up like this?

$x1 = Number(@DesktopWidth/2)
$y1 = Number(@DesktopHeight/2)


While 1
    $point = PixelGetColor($x1, $y1)
    
        If $point = 0xA00000 Then
            MouseClick($x1, $y1)
        EndIf
WEnd

[demandnothing]

of course.. but it wont respond

[bogQ]

are you setting it up like this?

$x1 = Number(@DesktopWidth/2)
$y1 = Number(@DesktopHeight/2)


While 1
    $point = PixelGetColor($x1, $y1)
    
        If $point = 0xA00000 Then
            MouseClick($x1, $y1)
        EndIf
WEnd

$point = "0x" & Hex ( PixelGetColor ( $x1 , $y1 ) , 6 )

Edited August 26, 2009 by bogQ