When Sending a UDP Message, using UDPOpen() and UDPSend(), can I get the Source Port that was Used?

[Zohar]

Hi all

I am sending a UDP Message using UDPOpen() and UDPSend().

I am specifying the Target_IP and Target_Port,
and would like to ask if AutoIt somehow enables me to get the Source_Port that was used for sending that UDP Message.

Thank you

Edited 2 hours ago by Zohar

[argumentum]

https://www.autoitscript.com/forum/topic/87856-udp-source-port/  🤔
https://www.autoitscript.com/trac/autoit/ticket/1869 🤷‍♂️

Edited 1 hour ago by argumentum

[Nine]

Not sure if this is what you want but I believe you can use $UDP_DATA_ARRAY (2) - returned in an Array : [0] data, [1] from IP, [2] from Port.  

Use 3 for both binary and array.  See UDPRecv in help file.