is it possible to hide and unhide a treeview?

[gcue]

hello

i have 2 tabs setup and i would like the treeview to show up under just one tab but it shows up on both.  i take it this doesn't work because a treeview is not a control?

$current_tab = GUICtrlRead($tabs)

    If $current_tab = 0 Then
        Debug(0)
        GUICtrlSetState($scan_treeview, $GUI_SHOW)
    EndIf

    If $current_tab = 1 Then
        Debug(1)
        GUICtrlSetState($scan_treeview, $GUI_HIDE)
    EndIf

i really would like to avoid destroying it and re-creating it because id like to keep all the values there.

thank you in advance!

[jguinch]

A treeview seems to have the same behaviour than another control with tabs :

#include <GUIConstantsEx.au3>

GUICreate("GUI", 180, 180)

GUICtrlCreateTab(10, 10, 150, 150)
GUICtrlCreateTabItem("First tab")

Local $idTreeview = GUICtrlCreateTreeView(50, 50, 100, 100)
GUICtrlCreateTreeViewItem("Item 1", $idTreeview)
GUICtrlCreateTreeViewItem("Item 2", $idTreeview)

GUICtrlCreateTabItem("Second tab")

GUISetState(@SW_SHOW)

While 1
    $msg = GUIGetMsg()
    Switch $msg
        Case $GUI_EVENT_CLOSE
            ExitLoop
    EndSwitch

WEnd

You have to create the tab control at the good place in the script

Edited June 23, 2016 by jguinch

[gcue]

looks like if i create the treeview with _GUICtrlTreeView_Create (which is what i was doing) it doesnt work but if i use GUICtrlCreateTreeView then it works.

thanks =)

Edited June 23, 2016 by gcue

[spudw2k]

I suspect that is because GUICtlSetState is expecting an AutoIT control id and not a control handle (returned by _GUICtlTreeView_Create).